Originally Posted by E4SS
Just posting progress on my mask. Got a GCFX version 1 mask that I'm following Banetico's model to try and make more accurate. I padded the inside where i needed it to (It looks messy, but no ones gonna look in there anyways!), molded a piece a plastic on the mouth piece so it holds its shape, and started using some epoxy putty to mold parts of the front! Open to any criticisms!
I didn't molded the actual nose of the mask (where the 4 teeth connectors are molded) because I think that part is fine. I only molded the silver connectors at the side of the nose since the originals are way too low.
The plastic tabs iside look good. Thy're bigger than the ones I did for my mask so hopefully that'lll help you maintain the maw's shape even better.
the foam sheets appear a tad too flimsy so my advice would be to glue several of them (3 may do it) and cut them in the shape of the internal spaces of the mask.
you want the padding to be as flat as possible all around so It won't hurt your skin.